Before the migration, consult the datasheet to make sure the new UniFi OS Console you will run UniFi Protect on supports the number of cameras you plan to migrate.. UniFi Protect supports all UVC (G2) and newer UniFi cameras. Navigate to the Devices tab. We provide step by step instructions and live support for migrating sites from an existing controller or adding a device. Follow the steps very carefully. To migrate my complete UniFi hardware to the new controller I keep the IP address of the controller the same. I decided to try out the process of moving controllers . How to migrate unifi controller : Ubiquiti Setting up a cloud server to run UniFi Controller Earlier, it would list the hardware appliance, the controller, and Protect (which I had turned on) as disparate entires in the controller. UISP - Migration Tool - Ubiquiti Support and Help Center Migrate Unifi Controller to New Server Time needed: 10 minutes. Install Unifi Network Controller on Synology - VMLabBlog.com 2. Device Migration. Install UniFi Controller on Docker. Within seconds of running the set-inform command the second time, you should see the status of the AP change to "Upgrading" (if a firmware update is applicable) and then to "Provisioning". Also, it has great support. Now we've got to migrate your current access points over the new controller. Select Config. 1. UniFi hosting - start UniFi controller in a matter of minutes ⏱️ The easiest way to restore UniFi configuration is during initial setup using the wizard, as shown below. Migrate UniFi AP to new UniFi Controller (without losing settings) Finally, enter a username and password for the VM admin. Once devices appear with a status of "connected" in the new controller site, you may select "forget devices".