user@hostname> debug software restart process device-server. Palo Alto firewall - CLI Commands Cheat Sheet ------ Table of Contents ------ Device Management Policies Networking User-ID HA VSYS Panorama Here are PAN-OS CLI commands. PA-7000 Series Firewall NPC Troubleshooting Commands ha_agent 6648 0 11 239500 29040 S. satd 6649 0 12 562168 39420 S . If the connection is Fiber, in addition to the steps described above perform the following: Ensure fiber connections are clean Try another transceiver and cable if fiber (SM or MM) Check power levels for fiber links to ensure the cable does not have signal loss Is it the correct type of transceiver? Email This BlogThis! . Conclusion Palo Alto Network troubleshooting CLI commands are used to verify the configuration and environmental health of PAN device, verify connectivity, license, VPN, Routing, HA, User-ID, logs, NAT, PVST, BFD and Panorama and others. A heartbeat connection between the firewall peers ensures seamless failover in the event that a peer goes down. Get My Palo Alto Networks Firewall Course here: https://www.udemy.com/course/palo-alto-networks-pcnse-complete-course-exam/?referralCode=F8B75F31D937FF56ED62. Mastering Palo Alto Networks [Book] - O'Reilly Media Jump to chapter . Troubleshooting Dynamic Updates on Palo Alto Firewalls Palo Alto Firewall - Packet Flow. GBIC, SFP, XFP, SFP+, QSFP, QSFP+, etc. Ask a Question. setup the management interface. Hence I referred to the CLI and looked up all commands to wipe and stage a new device for our environment. Replace a PA-5450 Front Slot Card in a High Availability (HA) Configuration .